Diagnostic Procedure
WARNING: This page is about a different variant/trim than selected.
- STEP 1. M.U.T.-III data list
Item 49: Transmission range switch
Check that the service data changes when the selector lever is moved to all ranges.
Q: Is the check result normal?
YES : Go to Step 2.
NO : Go to Step 3.
- STEP 2. Check of the transmission range switch and shift control cable
Refer to TRANSMISSION RANGE SWITCH AND CONTROL CABLE ADJUSTMENT .
Q: Is the check result normal?
YES : Go to Step 4.
NO : Adjust the transmission range switch and the control cable.
- STEP 3. Transmission range switch continuity check
Refer to TRANSMISSION RANGE SWITCH CONTINUITY CHECK .
Q: Is the check result normal?
YES : Go to Step 4.
NO : Replace the transmission range switch.
- STEP 4. Retest the system.
- Replace TCM.
- Recheck the trouble symptom.
Q: Does the malfunction take place again?
YES : Replace the CVT assembly.
NO : The inspection is complete.