LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2008 >> Outlander LS, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (CVT - On-Vehicle Service & Diagnosis) >> Diagnosis >> How To Initialize CVT Learned Value >> Initialization Procedure

Initialization Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Move the selector lever to the "P" range and turn the ignition switch to the "LOCK" (OFF) position. Then, connect M.U.T.-III to the diagnosis connector.
  2. Turn the ignition switch to the "ON" position, and then move the selector lever to the "R" range.
  3. Depress the accelerator pedal while depressing the brake pedal. (Engine stops) Erase the diagnosis code at this point.
NOTE: Performing initialization of the learned value will also erase the diagnosis code.
scientia non olet · About LEMON Manuals