Diagnostic Procedure
WARNING: This page is about a different variant/trim than selected.
- STEP 1. Check other diagnosis codes.
Q: Are other diagnosis codes set?
YES : Carry out the appropriate troubleshooting.
NO : Go to Step 2.
- STEP 2. M.U.T.-III data list
- Item 7: Primary speed
- Item 9: Engine revolution
OK: No considerable difference is observed between the primary pulley speed and the engine speed.
Q: Is the check result normal?
YES : Intermittent malfunction
NO : Go to Step 3.
- STEP 3. Line Pressure Check
Carry out "hydraulic test". Refer to HYDRAULIC PRESSURE TEST .
Q: Is the check result normal?
YES : Go to Step 4.
NO : Repair according to the hydraulic pressure test diagnosis table.
- STEP 4. Symptom recheck after erasing diagnosis code
Q: Is the check result normal?
YES : Intermittent malfunction
NO : Replace TCM.