Code No. U0245 AND CAN timeout: Diagnosis

Required Special Tools: 

• MB991958: Scan Tool (M.U.T.-III Sub Assembly)
  • MB991824: Vehicles Communication Interface (V.C.I.).
  • MB991827: M.U.T.-III USB Cable
  • MB991910: M.U.T.-III Main Harness A (Vehicles with CAN communication system)

1. STEP 1. Using scan tool MB991958, diagnose the CAN bus line 
   CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.
   1. Connect scan tool MB991958. Refer to "HOW TO CONNECT THE SCAN TOOL (M.U.T.-III)  ".
   2. Turn the ignition switch to the "ON" position.
   3. Diagnose the CAN bus line.
   4. Turn the ignition switch to the "LOCK" (OFF) position.

   Q: Is the CAN bus line found to be normal? 

   YES:  Go to Step 2.

   NO:  Repair the CAN bus line (Refer to DIAGNOSIS ).

   Fig 1: Connecting Special Tool To Data Link Connector

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2. STEP 2. Using scan tool MB991958, read the CAN box unit diagnostic trouble code 

   Check the DTC is set to the CAN box unit.

   Q: Is the DTC set? 

   YES:  Troubleshoot the CAN box unit (Refer to MMCS - DIAGNOSTIC TROUBLE CODE CHART ).

   NO:  Go to Step 3.

3. STEP 3. Recheck for diagnostic trouble code. 

   Check again if the diagnostic trouble code is set to the hands free module.

   1. Erase the diagnostic trouble code.
   2. Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
   3. Check if DTC is set.

   Q: Is the diagnostic trouble code set? 

   YES:  Replace the hands free module.

   NO:  The trouble can be an intermittent malfunction (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTIONS ).