LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2008 >> Outlander LS, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Chassis Electrical - 2 Of 5 >> Headlight >> Diagnosis >> Service Precautions Discharge Headlight >> 1. Checking Procedure For Discharge Headlight Related Parts (Inspection Procedure When Reusing The Controller) >> 1 - 2 Check Of Wiring Harness Between Controller And Bulb

1 - 2 Check Of Wiring Harness Between Controller And Bulb

If any of the check items below are found, replace the wiring harness between the controller and the bulb.

WARNING: If the wiring harness between the controller and the bulb is damaged, always replace it. Attempting to repair the wiring harness may cause a melted harness wire, or may result in a burn or death due to an electric shock by high voltage.
CHECK ITEMS CHART

Items to be checked Why the controller should be replaced
Wiring harness shield damaged Abnormal noise may cause.
Damaged connector (chipped or cracked plastics, or deformed terminal) The damaged part(s) may cause poor connection or short circuit.
scientia non olet · About LEMON Manuals