LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2008 >> Outlander LS, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Chassis Electrical - 2 Of 5 >> Headlight Automatic Levelling System >> Troubleshooting >> Symptom Procedures >> Inspection Procedure 3: One of the automatic leveling does not work. >> Diagnosis

Inspection Procedure 3: One of the automatic leveling does not work.: Diagnosis

  1. STEP 1. Check headlight leveling unit. 

    Perform a leveling motor drive test of the headlight leveling unit to check that the motor is driven. Refer to HEADLIGHT AUTOMATIC LEVELING MOTOR DRIVE TEST  .

    Q: Do Headlight leveling unit work normal? 

    YES:  The trouble can be an intermittent malfunction (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTIONS ).

    NO (The left leveling motor is not driven).  : Go to Step 2.

    NO (The right leveling motor is not driven).  : Go to  Step 5.

  2. STEP 2. Check headlight automatic leveling-ECU connector C-110, Headlight leveling unit (LH) connector A-37 for loose, corroded or damaged terminals, or terminals pushed back in the connector. 

    Q: Is headlight automatic leveling-ECU connector C-110, Headlight leveling unit (LH) connector A-37 in good condition? 

    YES:  Go to Step 3.

    NO:  Repair the damaged parts.

  3. STEP 3. Check wiring harness between headlight automatic leveling-ECU connector C-110 (terminal No. 2/3/4) and headlight leveling-unit (LH) connector A-37 (terminal No. 11/10/12). 

    Q: Is headlight automatic leveling-ECU connector C-110 (terminal No. 2/3/4) and headlight leveling-unit (LH) connector A-37 (terminal No. 11/10/12) in good condition? 

    YES:  Go to Step 4.

    NO:  Repair the wiring harness.

  4. STEP 4. Retest the system. 

    Check that the automatic leveling of the left headlight operates normally.

    Q: Is the check result normal? 

    YES:  The trouble can be an intermittent malfunction (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTIONS ).

    NO:  Replace the headlight assembly (LH).

  5. STEP 5. Check headlight automatic leveling-ECU connector C-110, Headlight leveling unit (RH) connector A-56 for loose, corroded or damaged terminals, or terminals pushed back in the connector. 

    Q: Is headlight automatic leveling-ECU connector C-110, Headlight leveling unit (RH) connector A-56 in good condition? 

    YES:  Go to Step 6.

    NO:  Repair the damaged parts.

  6. STEP 6. Check wiring harness between headlight automatic leveling-ECU connector C-110 (terminal No. 11/12/13) and headlight leveling-unit (LH) connector A-56 (terminal No. 11/10/12). 

    Q: Is headlight automatic leveling-ECU connector C-110 (terminal No. 11/12/13) and headlight leveling-unit (LH) connector A-56 (terminal No. 11/10/12) in good condition? 

    YES:  Go to Step 7.

    NO:  Repair the wiring harness.

  7. STEP 7. Retest the system. 

    Check that the automatic leveling of the right headlight operates normally.

    Q: Is the check result normal? 

    YES:  The trouble can be an intermittent malfunction (Refer to HOW TO COPE WITH INTERMITTENT MALFUNCTIONS ).

    NO:  Replace headlight assembly (RH)