LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2008 >> Outlander LS, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Chassis Electrical - 2 Of 5 >> Headlight Automatic Levelling System >> Inspection >> Height Sensor Check >> Rear Height Sensor Check

Rear Height Sensor Check

  1. Disconnect the sensor connector and connect the special tool test harness (MB991658) as shown.
  2. Turn the ignition switch to the ON position.
  3. Measure the voltage of sensor connector terminal No. 2.
    Fig 1: Checking Rear Height Sensor
    G05434387Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. Check that voltages show the values described in the graph according to the sensor operation angle.
    Fig 2: Voltage Graph
    G05434390Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals