LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2008 >> Outlander LS, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Chassis Electrical - 2 Of 5 >> Headlight Automatic Levelling System >> Inspection >> Height Sensor Check >> Front Height Sensor Check

Front Height Sensor Check

  1. Disconnect the sensor connector and connect the special tool test harness (MB991658) as shown.
  2. Turn the ignition switch to the ON position.
  3. Measure the voltage of sensor connector terminal No. 2.
    Fig 1: Checking Front Height Sensor
    G05434387Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. Check that voltages show the values described in the graph according to the sensor operation angle.
    Fig 2: Voltage Graph
    G05434388Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals