LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2008 >> Outlander LS, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Chassis Electrical - 2 Of 5 >> FOG LIGHT < Vehicles without discharge headlight > >> On-Vehicle Service >> Bulb Replacement

Bulb Replacement

  1. Remove the bolt under the fog light bracket and tilt the fog light to ease the bulb pulling-out.
    CAUTION: Don't touch the bulb surface with bare hands or dirty gloves. If the bulb surface (glass part) gets dirty, clean it with alcohol or thinner immediately and dry well, and then install it.
    Fig 1: Identifying Bolt And Fog Light Bracket
    G05434430Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Disconnect the connector and withdraw the bulb.
  3. Replace the bulb, and connect securely the connector.
    Fig 2: Locating Fog Light Bulb
    G05434431Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals