Technical Description (Comment)
When the following signals are received via the CAN communication, the combination meter sounds the incorporated tone alarm according to the each pattern.
Seat belt reminder function
- Ignition switch ON signal
- Vehicle speed signal
- Driver's seat belt switch signal
- Front passenger's seat belt switch signal
Keyless operation key reminder tone alarm function (vehicles with KOS)
- Ignition switch OFF signal
- IG knob push switch ON signal
- Driver's door switch ON signal
Ignition key reminder tone alarm function (vehicles without KOS)
- Ignition switch OFF signal
- Key reminder switch OFF signal
- Driver's door switch ON signal
Light reminder tone alarm function
- Ignition switch OFF signal
- Lighting switch ON signal
- Driver's door switch ON signal
Door-ajar warning tone alarm function
- Ignition switch ON signal
- Any door switch or liftgate switch ON signal
- Vehicle speed signal
Freeze warning tone alarm
- Ignition switch ON signal
- Ambient temperature signal
Parking brake reminder tone alarm function
- Ignition switch ON signal
- Parking brake switch ON signal
- Vehicle speed signal
- Engine speed
Multi information display interrupt display tone alarm
- Display condition signal of information display from each warning (When there is a fixed tone alarm sounding pattern for each warning, that pattern has the priority.)
Meter information switch operation tone alarm
- ON signal for combination meter information switch
Turn-signal light tone alarm function
- Turn-signal light switch ON signal
Paddle shift cancel tone alarm, Theft-alarm function, ETACS-ECU function customize tone alarm, A/C operation tone alarm, audio operation tone alarm
- Sounding request signal from the ETACS-ECU If the tone alarm does not sound normally, the connector(s) and wiring harness in the CAN bus lines, or each ECU or the combination meter may have a problem.