Fog Light Adjustment

Check if the beam shining onto the screen is at the standard value.
Standard value:

(Cutoff line direction): The horizontal line 153.0 mm (6.02 inches) (1.15 degrees angle) below the horizontal line (H)

Limit:

(Vertical direction): Area from 53.2 mm (2.09 inches) (0.4 degrees angle) above the cutoff line to 99.8 mm (3.93 inches) (0.75 degrees angle) below the cutoff line

(Horizontal direction): Vertical line (V) ± 599.7 mm (± 23.6 inches) (± 4.5 degrees angle)

Fig 1: Identifying Fog Light Adjustment Dimension
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
If it is not within the standard value range, adjust by turning the adjusting screw.
NOTE: The horizontal direction is non-adjustable. If deviation of the light beam axis exceeds the standard value, check that the mounting location or some other points are not faulty.

Fig 2: Adjusting Fog Light
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 3: Identifying Fog Light Adjustor
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.