Individual Component Service
WARNING:
- If heat damage occurs during paint work, remove the SRS-ECU, the driver's air bag module, the passenger's (front) air bag module, side-airbag modules, the clock spring, the seat slide sensor, and the seat belt with pre-tensioner. Recheck the SRS system operability after reinstalling them.
- SRS-ECU, the driver's air bag module, the passenger's (front) air bag module, side-airbag modules, clock spring, the seat slide sensor: 93°C (200°F) or more
- Seat belt with pre-tensioner: 90°C (194°F) or more
- If the SRS components are removed for the purpose of inspection, sheet metal repair, painting, etc., they should be stored in a clean, dry place until they are reinstalled.
If the SRS components are to be removed or replaced as a result of maintenance, diagnosis, etc., follow the appropriate procedure in this service information. (FRONT IMPACT SENSOR : refer to , SRS CONTROL UNIT (SRS-ECU) : refer to , AIR BAG MODULES AND CLOCK SPRING : refer to , SIDE IMPACT SENSOR : refer to , SEAT BELT WITH PRE-TENSIONER : refer to , SEAT SLIDE SENSOR : refer to ).