Diagnostic Trouble Code Chart
WARNING: This page is about a different variant/trim than selected.
CAUTION:
During diagnosis, a DTC code associated with another system may be set when the ignition switch is turned on with connector(s) disconnected. After completing the repair, confirm all systems for DTC code(s). If DTC code(s) are set, erase them all.
DIAGNOSTIC TROUBLE CODE CHART
| DTC NO. | DIAGNOSTIC ITEM |
|---|---|
| B1001 | Interior temperature sensor system (short circuit) |
| B1002 | Interior temperature sensor system (open circuit) |
| B1011 | Ambient temperature sensor system (short circuit) |
| B1012 | Ambient temperature sensor system (open circuit) |
| B1021 | Air thermo sensor system (short circuit) |
| B1022 | Air thermo sensor system (open circuit) |
| B1041 | Air mixing damper control motor and potentiometer (potentiometer system shorted to its power supply) |
| B1042 | Air mixing damper control motor and potentiometer (potentiometer system shorted to its ground or open circuit) |
| B1045 | Air mixing damper control motor and potentiometer (activating system failure) |
| B1061 | Mode selection damper control motor and potentiometer (potentiometer system shorted to its power supply) |
| B1062 | Mode selection damper control motor and potentiometer (potentiometer system shorted to its ground or open circuit) |
| B1065 | Mode selection damper control motor and potentiometer (activating system failure) |
| U1073 | Bus off |
| U1100 | Powertrain control module time-out (related to engine) |
| U1111 | Multi-center display unit (middle grade type) time-out |
| U1120 | Failure information on powertrain control module (related to engine) |