LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2007 >> Galant DE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Body) >> Window Glass >> Windshield >> Removal And Installation >> Removal Service Point >> << A >> Windshield Removal

<< A >> Windshield Removal

WARNING: This page is about a different variant/trim than selected.
  1. To protect the body (paint surface), apply cloth tape to all body areas around the installed windshield.
  2. Make mating marks on the windshield and body.
  3. Using piano wire.
    1. Using a sharp-point drill, make a hole in the windshield adhesive.
    2. Pass the piano wire from the inside of the vehicle through the hole.
      CAUTION: Do not let the piano wire touch the edge of the windshield.
    3. Pull the piano wire alternately from the inside and outside along the windshield to cut the adhesive.
      Fig 1: Cutting Windshield Adhesive
      G04255618Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
      CAUTION: Inserting the glass adhesive knife too deeply into windshield adhesive may damage windshield.
  4. Using glass adhesive knife

    Keep glass adhesive knife at right angles with the windshield edge, and put the blade at windshield edge and surface. Then cut away adhesive along the windshield edge.

    Fig 2: Identifying Glass Adhesive Knife
    G04237484Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    Fig 3: Cutting Adhesive With Glass Adhesive Knife
    G04255620Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  5. Use special tool MB990480 to remove the windshield.
    Fig 4: Removing Windshield
    G04255621Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    CAUTION:
    • Be careful not to remove more adhesive than is necessary.
    • Be careful also not to damage the paint on the body surface with the knife. If the paint is damaged, repair the damaged area with touch-up paint.
  6. Use a knife to cut away the remaining adhesive so that the thickness is within 2 mm (0.08 inch) around the entire circumference of the body flange.
  7. Finish the flange surfaces so that they are smooth.
    CAUTION: Allow the cleaned area to dry for at least three minutes. Do not touch any surface that has been cleaned.
  8. When reusing the windshield, remove the adhesive still adhering to the windshield, and clean with 3M™ AAD Part number 8906 or equivalent.
  9. Clean the body side in the same way.
    Fig 5: Cutting Remaining Adhesive
    G04237487Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.