INSPECTION PROCEDURE 2: The screen is not displayed with ACC-ON: Diagnosis

STEP 1. Check if the screen off mode is set.
1. Turn the ignition switch to the "ON" position.
2. Check that the transition to the screen off mode is performed after a few seconds.
Q: Is the screen off mode set?

YES: Set to cancel the screen off mode. Check that the screen is displayed with ACC-ON.

NO: Go to Step 2.
STEP 2. Check if the screen is displayed with ACC-ON.
1. Turn the ignition switch to the "ON" position.
2. Check that the screen is displayed to the multi-center display.
Q: Is the screen is displayed with ACC-ON?

YES: The procedure is complete.

NO: Replace the multi-center display. Check that the screen is displayed with ACC-ON.