Fog Light Adjustment

Check if the beam shining onto the screen is at the standard value.

Fig 1: Identifying Height Of Fog Light Center
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
If it is not within the standard value range, adjust by turning the adjusting screw.
Standard value: (Vertical direction): Top of the hot zone should be 101 mm (4.0 inches) (0.76 degrees angle) downward from the height of the fog light center.

Limit: (Vertical direction): Top of the hot zone should be 152 mm (6.0 inches) (1.14 degrees angle) in maximum downward from the height of the fog light center.

Fig 2: Identifying Adjusting Screw
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

NOTE: The horizontal direction is non-adjustable. If deviation of the light beam axis exceeds the standard value, check that the mounting location or some other points are not faulty.