INSPECTION PROCEDURE 4: Remote controlled radio switch: The system does not recognize the remote controlled radio switch (LH) only. < Vehicles with audio amplifier>: Diagnosis

Required Special Tools: 

• MB991223: Harness set
• MB992006: Extra Fine Probe

1. STEP 1. Measure the resistance at remote controlled radio switch (LH). 
   1. Remove the airbag module assembly (Refer to AIR BAG MODULE(S) AND CLOCK SPRING ).
   2. Measure the resistance by operating the remote controlled radio switch (LH) in each position.
   RESISTANCE SPECIFICATION
   
   

   SWITCH POSITION	MEASUREMENT VALUE
   Not pushed	Approximately 24 kΩ
   Upper	Approximately 1.1 kΩ
   Center	Approximately 460 Ω
   Lower	Approximately 2.9 kΩ

   Q: Is the resistance at the left remote controlled radio switch normal? 

   YES:  Go to Step  2.

   NO:  Replace the remote controlled radio switch (LH).

   Fig 1: Measuring Resistance Between Remote Controlled Radio Switch Terminals (LH)

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2. STEP 2. Check the radio switch (LH) connector C-311 and clock spring connector C-303 for loose, corroded or damaged terminals, or terminals pushed back in the connector. 

   Q: Is remote controlled radio switch (LH) connector C-311 and clock spring connector C-303 in good condition? 

   YES:  Go to Step  3.

   NO:  Repair or replace the connector. Refer to HARNESS CONNECTOR INSPECTION . The remote controlled radio switch (LH) should work normally.

   Fig 2: Locating Radio Switch (LH) Connector C-311 And Clock Spring Connector C-303

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
3. STEP 3. Check the wiring harness between remote controlled radio switch connector C-311 (terminals 1 and 2) and clock spring connector C-303 (terminals 4 and 5). 

   Q: Are the wiring harness between remote controlled radio switch connector C-311 (terminals 1 and 2) and clock spring connector C-303 (terminals 4 and 5) in good condition? 

   YES:  No action to be taken.

   NO:  Repair the wiring harness. The remote controlled radio switch (LH) should work normally.

   Fig 3: Locating Radio Switch (LH) Connector C-311 And Clock Spring Connector C-303

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.