INSPECTION PROCEDURE 25: CD player, CD auto changer: No sound (CD only): Diagnosis
- STEP 1. Check again using another CD, which is not dirty or scratched.
Q: When you substitute another normal CD, is the CD played normally?
YES: The original CD is defective. The CD player should sound normally.
NO: Go to Step 2.
- STEP 2. Check power supply to the CD player when the ignition switch is at "ACC" or "ON" position.
Q: Is the radio and CD player energized when the ignition switch is turned to the "ACC" or "ON" position?
YES: Replace the radio and CD player or radio and CD player with CD changer. The CD player should sound normally.
NO: Check the memory backup power supply circuit. Refer to INSPECTION PROCEDURE 1: WHEN POWER SWITCH IS TURNED "ON," NO POWER IS AVAILABLE. .