INSPECTION PROCEDURE 24: CD player, CD auto changer: CD can not be Inserted: Diagnosis
- STEP 1. Check that a CD has been already loaded.
Q: Has a CD been already loaded?
YES: Take out the CD (If the CD can not be ejected, refer to INSPECTION PROCEDURE 28: CD PLAYER, CD AUTO CHANGER: CD CANNOT BE EJECTED. ). Check that a CD can be inserted.
NO: Go to Step 2.
- STEP 2. Check how a CD is inserted.
Ensure that the ignition switch is at `ACC' or `ON'.
NOTE: If you try to load a CD when the ignition switch is at the positions other than 'ACC' or 'ON,' the CD will not be inserted completely and then rejected.Q: If you try to load the CD, does the CD stops halfway and then rejected?
YES: Refer to INSPECTION PROCEDURE 27: CD PLAYER, CD AUTO CHANGER: SOUND QUALITY IS POOR. .
NO: Go to Step 3.
- STEP 3. Check after the CD is loaded. NOTE: Even though the CD is loaded, 'E01' [vehicles with multi-center display (low grade type)] or `ERROR 01' [vehicles with multi-center display (middle grade type)] sometimes displayed with the CD rejected because of vibration/shock or dew on the CD face or optical lens.
Q: Though the CD is inserted completely, is 'E01' [vehicles with multi-center display (low grade type)] or 'ERROR 01' [vehicles with multi-center display (middle grade type)] displayed and the CD ejected?
YES: Go to Step 4.
NO: There is no action to be taken.
- STEP 4. Check the CD.
Check the CD for the conditions below:
- Is the CD loaded with its label facing down?
- Is the recorded face dirty or scratched?
- Is there dew on the recorded face?
Q: Is the CD in good condition?
YES: Go to Step 5.
NO: The original CD is defective. Check that a known good CD can be inserted.
- STEP 5. Check again using a normal CD, which is not dirty or scratched.
- Load another normal CD.
- Check that the CD player recognizes and plays the CD.
Q: When you substitute another normal CD, is the CD loaded correctly?
YES: The original CD is defective. Check that a CD can be inserted.
NO: Replace the CD player. Check that a CD can be inserted.