Remote Controlled Radio Switch Continuity Check
Use an ohmmeter to measure the resistance value between the terminals.
RESISTANCE SPECIFICATION
| SWITCH POSITION | MEASUREMENT VALUE (RH) | MEASUREMENT VALUE (LH) |
|---|---|---|
| Not pushed | Approximately 24.0 kΩ | Approximately 24 kΩ |
| Upper | Approximately 5.3 kΩ | Approximately 1.1 kΩ |
| Center | Less than 2 ohms | Approximately 460 kΩ |
| Lower | Approximately 9.2 kΩ | Approximately 2.9 kΩ |