LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2007 >> Eclipse GT, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Chassis Electrical >> Radio With Cd Player >> Radio With Cd Player, Speaker And Antenna Diagnosis >> Introduction To Audio System Diagnosis >> Audio Error Codes

Audio Error Codes

If the radio and CD player or radio and CD player with CD changer detects any malfunction in itself or the inserted CD, the error codes below will be shown on the multi-center display.

AUDIO SYSTEM DIAGNOSTIC CHART

ERROR CODES CAUSE CAUSE OF TROUBLE AND ITS SOLUTION
E01 Focus error If there is any problem on the CD, this error code will be shown. If no error message appears when another disc is inserted, the disc is defective. Check the items below, and take a necessary action.
  • Contamination, scratch, or deformation
  • Formation of moisture or grease

Insert the disc again, and check that no error appears.
E02 Abnormal disc
E03 Mechanical error This error codes will be shown if there is any internal mechanical or electrical problem in the radio and CD player or radio and CD player with CD changer. Replace the radio and CD player or radio and CD player with CD changer, and check that no error codes are shown.
E HOT Protection against high temperature If the internal temperature is extremely high, this error code will be shown. Turn off the radio and CD player or radio and CD player with CD changer and wait until they cool down. Wait for a while, and then turn on the unit again. Check that the same error does not appear.
E Com Communication or power supply error If this error code is displayed, the power supply for the radio and CD player or radio and CD player with CD changer is defective. Check that the wiring of the radio and CD player or radio and CD player with CD changer is connected correctly. Check that the same error does not appear.
E DC Detection abnormal output to the speaker When the foreign material such as a coin and drink goes into the unit and DC offset is occurred in the signal input part of the power IC, this error code will be shown. When a liquid goes inside of the unit, turn off the radio and leave for a while and make it dry. Then turn on the radio and check the same error code does not appear. When a solid goes inside, replace the unit (head unit or amplifier).
scientia non olet · About LEMON Manuals