Room light delay shutdown function

The room light off is delayed by ETACS-ECU. The lights off delay time vary according to the conditions. The control details are as follows. The light delay off Yes/NO and delay time can be set with the settings (adjustment function). Refer to ADJUSTMENT PROCEDURES OF SWS FUNCTION for adjustment methods and adjustment details (post-adjustment operations).

• The room light lights up if the ignition switch is at the "LOCK" (OFF) position and either of the doors are opened (either of the door switches: ON). At this time, if all doors are closed (all door switches: OFF) then the light will gradually dim down to lights off in about 30 seconds.
  NOTE: When the lights are dimmed and the ignition switch is turned ON or if the door is locked, then the dimming operations stop and the lights are turned OFF.
• When the ignition switch is at the ON position and one of the doors are opened (one of the door switches: ON) then the room light will light up. At this time, if all doors are closed (all door switches: OFF) then the lights will dim out.
• When the ignition key is pulled out the room light lights up and then will dim out in 30 seconds. The light will dim out if the ignition key is inserted again and the door is locked while the timer is activated.

The dome light is controlled by the Simplified Wiring System (SWS). For troubleshooting, refer to SWS DIAGNOSIS .