LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2005 >> Endeavor LS, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Emission Control >> Evaporative Emission Canister And Fuel Tank Pressure Relief Valve >> Inspection >> Evaporative Emission Ventilation Solenoid Check

Evaporative Emission Ventilation Solenoid Check

  1. Connect a hand vacuum pump to nipple (A) of the solenoid.
  2. Check air tightness by applying a vacuum with voltage applied directly from the battery to the evaporative emission ventilation solenoid and without applying voltage.
    VOLTAGE SPECIFICATION

    BATTERY VOLTAGE  NORMAL CONDITION 
    Applied Vacuum maintained
    Not applied Vacuum leaks
  3. Measure the resistance between the terminals of the solenoid.
    1. Standard value: 17-21 +/- [at 20°C (68°F)] 
      Fig 1: Checking Evaporative Emission Ventilation Solenoid
      G02393450Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
      Fig 2: Measuring Resistance Between Terminals Of Solenoid
      G02393451Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals