LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2005 >> Endeavor LS, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Chassis Electrical >> Radio With Tape Player And Cd Player >> Symptom Procedures >> INSPECTION PROCEDURE 17: No Reception (AM). >> Diagnosis

INSPECTION PROCEDURE 17: No Reception (AM).: Diagnosis

  1. STEP 1. Check the state of the antenna. 

    Q: Is the mast antenna assembled? 

    1. YES  : Go to Step 2.
    2. NO  : Assemble the mast antenna. The radio should sound normally.
  2. STEP 2. Check to see if inspections are taking place is an area exposed to special electric fields. 

    Q: Are inspections taking place under special electric field conditions (underground garage, inside a building, etc.)? 

    1. YES  : Go to Step 3.
    2. NO  : Go to  Step 4.
  3. STEP 3. Move the vehicle and check the radio. 

    Move the vehicle to a good reception area that is not exposed to special electric fields.

    Q: Is reception of the strongest radio frequency possible within the area? 

    1. YES  : There is no action to be taken.
    2. NO  : Go to Step 4.
  4. STEP 4. Tune the radio, and then check it. 

    Q: Did the sensitivity improve after tuning? 

    1. YES  : There is no action to be taken.
    2. NO  : Go to Step 5.
  5. STEP 5. Check the connection of the antenna plug and radio and CD player. 

    Q: Is the antenna plug thoroughly connected to the radio and CD player? 

    1. YES  : Go to Step 6.
    2. NO  : Thoroughly connect the antenna plug and the radio and CD player. The radio should sound normally.
  6. STEP 6. Check by replacing radio and CD player. 

    Q: Do the other radio and CD player work normally? 

    1. YES  : Either repair or replace the original radio and CD player. The radio should sound normally.
    2. NO  : Either repair or replace the antenna assembly. The radio should sound normally.
scientia non olet · About LEMON Manuals