Start service function
- Press the "ADJ" switch with the ignition switch at "LOCK" (OFF) position, and while keeping on pressing, turn the ignition switch to the "ACC" or "ON" position. When the ADJ switch is pressed continuously for more than five seconds, the service function is activated at the same time with the reception signal (pip sound) and the first menu screen of the service mode is displayed.
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
- When respective function switches are pressed on this screen, the screen is switched as follows.
- When the function switch 1 [AUTO] is pressed, the screen is switched to the automatic check mode.
- When the function switch 2 [DIAG] is pressed, the screen is switched to the diagnosis mode.
- When the function switch 3 [HISTORY] is pressed, the screen is switched to the history mode.
- When the "ADJ" switch [NEXT] is pressed, the screen is switched to the service mode second menu screen.
- When the "DISP" switch [NEXT] is pressed, the service mode is terminated.
- When the function switch 1 is pressed on this screen, the screen is switched as follows.
- When the function switch 1 [MONITOR] is pressed, the screen is switched to the monitor check mode.
- When the "ADJ" switch [BACK] is pressed, the screen is switched to the service mode first menu screen.
- When the "DISP" switch [END] is pressed, the service mode is terminated.
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.