Monitor check mode

Press the "ADJ" switch with the ignition switch at "LOCK" (OFF) position, and while keeping on pressing, turn the ignition switch to the "ACC" or "ON" position. When the "ADJ" switch is pressed continuously for more than five seconds, the service function is activated at the same time with the reception signal (pip sound) and the first menu screen of the service mode is displayed.

Fig 1: Service Mode First Menu Screen
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Press the "ADJ" [NEXT] switch.
The screen is switched to the service mode second menu screen.

Fig 2: Service Mode Second Menu Screen
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Press the function switch 1 [MONITOR]. The screen is switched to the monitor check mode.

Fig 3: Monitor Check Mode Screen

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

When respective function switches are pressed on this screen, the screen is switched as follows.
- When the function switch 1 [DISP] is pressed, the screen is switched to the display check mode.
- When the function switch 2 [COMP.] is pressed, the screen changes to the geomagnetic sensor check mode.
- When the "ADJ" switch is pressed, the screen changes to the service mode second menu screen.