Checking connection of system

When the connection data has disappeared, turning the ignition key to "ACC" position will make the following message appear.

1. Start the engine (or turn the ignition key to "ON" position).
   Fig 1: Starting Engine Screen

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2. When the engine is started or when the ignition key is in the "ON" position, the monitor will display the message.
   Fig 2: Checking System Connection Screen

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
3. After a short while the system will beep. When the connection is completed, the message will be displayed.
   Fig 3: Completion Connection System Screen

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.