Step 7: Measure At Combination Meter Connector C-01 In Order To Check The Ground Circuit To The Combination Meter

• Disconnect combination meter connector C-01, and measure at the wiring harness side.
• Measure the resistance between terminal No. 1 and ground. See Fig 1 . The measured value should be 2 ohms or less.
• Measure the resistance between terminal No. 2 and ground. See Fig 1 . The measured value should be 2 ohms or less.

Does the measured voltage correspond with this range?

• YES
  
  Repair the combination meter. Check to see that all meters operate.
• NO
  
  Go to step 8  .

Fig 1: Measuring Resistance Between Connector C-01 Terminal No. 1 & Ground

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.