LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2003 >> Lancer LS >> Repair and Diagnosis >> Electrical >> Gauges >> Gauges & Instrument Panels - Except Evolution >> Symptom Procedures >> Inspection Procedure 6: Combination Meter Does Not Work >> Diagnosis >> Step 6: Check The Wiring Harness Between Combination Meter Connector C-01 (Terminal No. 9) And Ignition Switch (IG1)

Step 6: Check The Wiring Harness Between Combination Meter Connector C-01 (Terminal No. 9) And Ignition Switch (IG1)

NOTE: Also check junction block connectors C-211, C-214 and joint connector (5) C-21. If junction block connectors C-211, C-214 or joint connector (5) C-21 are damaged, repair or replace the connector.

Are the wiring harness between combination meter connector C-01 (terminal No. 9) and ignition switch (IG1) in good condition?

scientia non olet · About LEMON Manuals