Step 4: Check The Harness Wires Between Engine Coolant Temperature Gauge Unit Connector B-38 And Combination Meter Connector D-03
NOTE:
After checking intermediate connector E-111, check the wire. If intermediate connector E-111 is damaged, repair or replace it.
Are the harness wires between engine coolant temperature gauge unit connector B-38 and combination meter connector D-03 in good condition?
- YES
Repair or replace the combination meter (printed-circuit board or engine coolant temperature gauge assembly). The engine coolant temperature gauge should work normally. - NO
Repair them. The engine coolant temperature gauge should work normally.