Step 4: Check The Harness Wires Between Fuel Gauge Unit Connector G-03 And Combination Meter Connector D-03
NOTE:
After checking intermediate connector F-07, D-111 and joint connector D-29, check the wire. If intermediate connector F-07, D-111 and D-29 are damaged, repair or replace them.
Are the harness wires between fuel gauge unit connector G-03 and combination meter connector D-03 in good condition?
- YES
Repair or replace the combination meter (printed-circuit board or fuel gauge assembly). The fuel gauge should work normally. - NO
Repair them. The fuel gauge should work normally.