LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2002 >> Lancer LS >> Labor Times >> Other Variant >> Brakes >> Mechanical - Hydraulic >> Brake Shoes &/Or Pads >> Remove & Replace

Brake Shoes &/Or Pads: Remove & Replace

WARNING: This page is about the Lancer ES, Automatic, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.

Applies ToNoteStandard HoursWarranty HoursSkill Level
All,Both Axles2.2B
Front,Both Sides1.0B
Rear,Both Sides1.4B
Combination Procedure: AXLE OR WHEEL BEARING: Repack:
Rear,EachNot Repackable.B
Combination Procedure: AXLE OR WHEEL BEARING: Replace:
FWD, Rear,One Side1.6B
Front,One Side2.2B
Combination Procedure: BRAKE HOSE: Replace:
Includes: Bleed System.
Power-Assist (Non-ABS), Each Additional0.2B
Power-Assist (Non-ABS), One0.3B
Combination Procedure: CALIPER: Overhaul:
Includes: Bleed System.
Power-Assist (Non-ABS), One0.5B
OneIncludes: Bleed Brakes.0.5B
Combination Procedure: CALIPER: Replace:
Includes: Bleed System.
Power-Assist (Non-ABS), One0.3B
Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle:
0.5B
Combination Procedure: DISC ROTOR (REMOVED): Refinish:
DOES NOT include grind hot spots.
Each Additional0.3B
One0.5B
Combination Procedure: PARKING BRAKE SHOE & LINING: Replace:
Each Side0.4B
Combination Procedure: WHEEL CYLINDER: Overhaul:
Includes: Bleed System.
One,Off Vehicle0.5B
One,On Vehicle0.3B