Montero Sport

Remove hazard light switch from instrument panel. Disconnect switch connector. Using an ohmmeter, check switch continuity. With switch off, continuity should exist between terminals No. 5 and 7, and between terminals No. 9 and 10. With switch on, continuity should exist between terminals No. 1, 2 and 4, terminals No. 5 and 6, and between terminals No. 9 and 10. See Fig 2 . If continuity is not as specified, replace hazard light switch.

Fig 1: Hazard Light Switch Connector Terminals (Montero)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Hazard Light Switch Connector Terminals (Montero Sport)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA