LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2001 >> Eclipse GS, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Front Brake Rotor >> Installation (Montero & Montero Sport)

Installation (Montero & Montero Sport)

  1. Install rotor on hub. Service wheel bearings and seals as necessary. Install front hub assembly. Install lock nut. Tighten nut to specification. See TORQUE SPECIFICATIONS . Loosen lock nut 30-40 degrees. Install lock washer and screw(s).
  2. On 2WD, reverse removal procedure for remaining components. On 4WD, install drive flange, shim and snap ring. Using feeler gauge, check axle shaft-to-hub clearance. Clearance should be 0.016-0.028" (0.41-0.71 mm). Use appropriate shim to obtain correct clearance. Shim is located behind snap ring on end of axle shaft. Recheck clearance if necessary. Install remaining components.
scientia non olet · About LEMON Manuals