FOGLIGHT Switch Test

Remove foglight switch from instrument panel. Disconnect switch connector. Using an ohmmeter, check switch continuity. With switch in OFF position, continuity should exist between terminals No. 4 and 5. With switch in ON position, continuity should exist between terminals No. 4 and 5 and terminals No. 6 and 7. See Fig 1 or Fig 2 . If continuity is not as specified, replace foglight switch.

Fig 1: Foglight Switch Connector Terminals (Eclipse)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Foglight Switch Connector Terminals (Galant)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA