Resistance Test

Remove instrument cluster. See INSTRUMENT CLUSTER under REMOVAL & INSTALLATION.
On all models, check resistance between appropriate terminals of instrument cluster or combination gauges. See Fig 2 or Fig 3 . See FUEL GAUGE RESISTANCE SPECIFICATIONS table. If resistance readings are not as specified, replace fuel gauge.

FUEL GAUGE RESISTANCE SPECIFICATIONS

Terminals ⁽¹⁾

Ohms

A & B

80-98

A & C

93-113

B & C

173-211

⁽¹⁾	For terminal locations, See Fig 2 or Fig 3 .

Fig 1: Checking Power To Fuel Gauge

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Instrument Panel Fuel Gauge Test Pins (With Tachometer)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA

Fig 3: Instrument Panel Fuel Gauge Test Pins (Without Tachometer)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA