LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 1999 >> Eclipse Spyder GS-T, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Removal & Installation >> Front Brake Rotor >> Installation (Montero & Montero Sport)

Installation (Montero & Montero Sport)

  1. Install rotor on hub. Service wheel bearings and seals as necessary. Install front hub assembly. Install lock nut. Tighten nut to 119 ft. lbs. (161 N.m) on Montero, or 94-145 ft. lbs. (127-197 N.m) on Montero Sport. Loosen lock nut, and retighten it 18 ft. lbs. (24 N.m). Loosen lock nut 30-40 degrees. Install lock washer and screw(s).
  2. On 2WD, reverse removal procedure for remaining components. On 4WD, install drive flange, shim and snap ring. Using feeler gauge, check axle shaft-to-hub clearance. Clearance should be 0.016-0.028" (0.41-0.71 mm). Use appropriate shim to obtain correct clearance. Shim is located behind snap ring on end of axle shaft. Recheck clearance if necessary. Install remaining components.
scientia non olet · About LEMON Manuals