Hazard Light Switch Test: 3000GT

Remove hazard light switch from instrument panel. Disconnect switch connector. Using an ohmmeter, check switch continuity. With switch in OFF position, continuity should exist between terminals No. 2 and 3, and between terminals No. 5 and 8. With switch in ON position, continuity should exist between terminals No. 2 and 3, between terminals No. 6, 9 and 10, and between terminals No. 7 and 8. See Fig 1. If continuity is not as specified, replace hazard light switch.

Fig 1: Hazard Light Switch Connector Terminals (Except Galant) & Foglight Switch Connector Terminals (3000GT)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA

Fig 2: Hazard Light Switch Connector Terminals (Galant)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA