FOGLIGHT Switch Test: 3000GT

Remove foglight switch from instrument panel. Disconnect switch connector. Using an ohmmeter, check switch continuity. With switch in OFF position, continuity should exist between terminals No. 3 and 4. With switch in ON position, continuity should exist between terminals No. 1 and 5. See Figure. If continuity is not as specified, replace foglight switch.

Fig 1: Foglight Switch Connector Terminals (Eclipse & Mirage)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA

Fig 2: Foglight Switch Connector Terminals (Galant)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA

Fig 3: Foglight Switch Connector Terminals (Montero)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA

Fig 4: Foglight Switch Connector Terminals (Montero Sport)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA