SRS Warning Light Comes On
WARNING: This page is about a different car, the 1995 Mitsubishi Galant. However, it is still accessible from the selected car via links, so may be relevant.
- Before proceeding, read and understand all air bag service precautions. See SERVICE PRECAUTIONS . Check for discharged battery. If battery is okay, turn ignition switch to LOCK position. Disconnect negative battery cable. Shield cable terminal. Wait at least 60 seconds before servicing.
- Remove rear console assembly for access to SDU. See Figure & 6. At SDU connector, use a screwdriver to push lock spring horizontally (toward SDU) to unlock lock lever (DO NOT insert screwdriver between lock lever and lock spring). See Figure . Press and hold lock lever in, and disconnect SDU Red 14-pin connector.
- Reconnect negative battery cable. Turn ignition switch to ON position. If SRS warning light illuminates, replace SRS wiring harness. If SRS warning light fails to illuminate, replace the SDU.