Rear Suspension Assembly: Removal
- Remove trunk lid. On FWD models, remove rear crossmember undercover panel. Remove center exhaust pipe. On AWD models, mark drive shaft flange and differential flange for installation reference. Disconnect drive shaft, and secure it using wire. On all models, remove brake caliper or drum.
- Disconnect parking brake cable. On drum brake models, disconnect and plug hydraulic brake hose. Remove upper arm bracket mounting bolts. Remove cap from top of shock. Remove shock absorber upper mounting nuts. On models with anti-lock brakes, disconnect electrical harness connectors.
- Remove frame grommet to access trailing arm front mounting bolt. Disconnect trailing arm. Support crossmember on FWD vehicles or differential on AWD vehicles with a floor or transmission jack. Remove nuts connecting rear suspension crossmember to body. Lower rear suspension assembly.