LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 1994 >> Eclipse Base, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.8L 4-CYL - VIN [B] & 2.0L 4-CYL - VINS [E,F] >> Removal & Installation >> Engine >> Removal

Removal & Installation: Engine: Removal

  1. Remove hood. Drain cooling system. Release residual fuel pressure from fuel system. See FUEL PRESSURE RELEASE  under REMOVAL & INSTALLATION.
  2. Drain engine oil and transaxle oil. Remove transaxle. On M/T models, see appropriate article in CLUTCHES. On A/T models, see TRANSMISSION REMOVAL & INSTALLATION article in TRANSMISSION SERVICING.
  3. Remove radiator and cooling fan assembly. Disconnect all necessary electrical connectors, vacuum hoses, fuel hoses and cables. Leaving hoses connected, remove power steering pump and A/C compressor, and support aside using wire.
  4. Disconnect exhaust pipe from exhaust manifold. Using lifting device, support weight of engine. Remove upper engine mount bracket assembly. Raise engine slightly. Ensure all cables, hoses and electrical harnesses are disconnected from engine. Lift engine upward from engine compartment.
scientia non olet · About LEMON Manuals