Installation (2.0L DOHC)
- Lubricate oil pump gears with engine oil, and install. Ensure timing marks are aligned. Install oil pump cover, and tighten bolts to specification. See TORQUE SPECIFICATIONS at end of article.
- If crankshaft oil seal was removed, use Seal Installer (MD998375-01) to install seal in front cover. Use a socket of proper diameter to install silent shaft oil seals.
- Position Oil Seal Guide (MD998285) over front of crankshaft. Lubricate crankshaft oil seal and oil seal guide with engine oil. Install front cover with new gasket, and temporarily tighten bolts. Install oil filter bracket. Ensure correct length bolts are installed.
- To complete installation, reverse removal procedure. Install plug cap using new "O" ring, and tighten to specification. Apply thread sealant to oil pressure switch threads before installing. Tighten all bolts to specification. See TORQUE SPECIFICATIONS at end of article.
OIL PUMP SPECIFICATIONS (2.0L)
| Application | Specification | ||
|---|---|---|---|
| Gear Side Clearance | |||
| Drive Gear | |||
| Standard | .0031-.0055" (.080-.140 mm) | ||
| Limit | .0098" (.250 mm) | ||
| Driven Gear | |||
| Standard | .0024-.0047" (.060-.120 mm) | ||
| Limit | .0098" (.250 mm) | ||
| Gear-To-Front Cover Clearance | |||
| Drive Gear | |||
| Standard | .0063-.0083" (.160-.210 mm) | ||
| Limit | .0098" (.250 mm) | ||
| Driven Gear | |||
| Standard | .0051-.0071" (.130-.180 mm) | ||
| Limit | .0098" (.250 mm) | ||