Removal (AWD)
- Disconnect parking brake cable end. Remove bracket for parking brake cable and speed sensor cable (if equipped). Remove rear brake assembly, and suspend caliper using wire. Remove brake disc.
- Disconnect drive axle from axle shaft companion flange. Hold hub using Yoke Holder (MB990767-01), and remove companion flange-to-axle shaft nut. Remove companion flange. Remove rear speed sensor and "O" ring (if equipped). Loosen upper and lower arm ball joint nuts, and disconnect ball joints.
- Remove trailing arm installation nut and bolt. Disconnect shock absorber from trailing arm. Remove trailing arm. Check trailing arm and bushing for cracks, deterioration and wear. Replace components as necessary.