LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 1992 >> Expo SP, FWD, Automatic >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Suspension - Rear >> Removal & Installation >> Shock Absorbers >> Removal (Except Precis)

Removal (Except Precis)

  1. On Colt, Colt 200, Mirage and Summit hatchback models, remove trunk side trim. On Diamante, Eclipse, Galant, Stealth and 3000GT, remove trunk side trim or shock/strut access cover. On Colt Vista, Expo/Expo LRV and Summit Wagon, remove shock/strut access cover.
  2. On all models, raise and support vehicle. Remove wheel assembly. Support lower arm assembly using jack stands. On models with electronically controlled suspension, disconnect electrical connector from top of shock and remove actuator.
    CAUTION: On models with spring assisted shock absorbers, DO NOT remove center strut rod nut until spring is compressed.
  3. On all models, remove dust cap from top of shock assembly. Raise lower arm assembly using a jack. Remove mount nuts, and disconnect upper shock mount from body. Disconnect shock from lower arm assembly. Lower jack, and remove shock assembly from vehicle.
scientia non olet · About LEMON Manuals