Removal & Installation (Pickup & Ram-50)

1. Disconnect negative battery cable. Remove hazard switch. On A/T models, remove hole cover. On M/T models, starter unlock switch will be in place of hole cover. On all models, remove instrument cluster cover.
2. Remove mounting screws from cluster. Remove cluster. Disconnect speedometer cable and electrical connectors from back of cluster. Remove cluster assembly. To install, reverse removal procedure. See Fig 1 or Fig 2 .

Fig 1: Instrument Cluster Component ID (Pickup & Ram-50) (W/ Tach)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Instrument Cluster Component ID (Pickup & Ram-50) (W/O Tach)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.