LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 1992 >> 3000GT SL, Standard >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Suspension - Electronic >> Removal & Installation >> Steering Wheel Angular Velocity Sensor >> Installation

Steering Wheel Angular Velocity Sensor: Installation

  1. To install, gently position sensor in steering column. DO NOT bend or contaminate slit plate. Install mounting screws and wire connector. Apply conductive grease to horn contact ends.
  2. Before installing clockspring, ensure clockspring is properly aligned. See CLOCKSPRING under ADJUSTMENTS. Install clockspring, steering wheel and air bag module. After installation is complete, check Supplemental Restraint System (SRS).
  3. Turn ignition on from passenger seat. SRS warning light in instrument cluster should illuminate for approximately 7 seconds and then go out. If SRS warning light fails to come on, remains on or flashes, a problem exists in SRS. Service SRS as soon as possible. Clockspring mating mark must be properly aligned. If clockspring is improperly aligned, steering wheel may not turn completely or flat cable inside clockspring may be severed, damaging air bag system.
scientia non olet · About LEMON Manuals