LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 1991 >> Precis Base, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.5L 4-CYL - VINS [A,J,X] & 1.6L 4-CYL - VIN [Y] >> Removal & Installation >> Rear Crankshaft Oil Seal >> Removal

Rear Crankshaft Oil Seal: Removal

Remove transaxle. See appropriate article in CLUTCHES or TRANSMISSION SERVICING. Remove flywheel (M/T) or drive plate (A/T). Remove oil seal case from rear of cylinder block. If necessary, remove oil pan. Remove oil seal from seal case. On 1.6L engines, an oil separator plate is located behind oil seal in oil seal case.

CAUTION: On 1.6L engines, ensure oil separator plate is installed with oil hole located toward oil pan sealing area, at bottom of oil seal case.
scientia non olet · About LEMON Manuals