LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 1991 >> Precis Base, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.5L 4-CYL - VINS [A,J,X] & 1.6L 4-CYL - VIN [Y] >> Removal & Installation >> Cylinder Head >> Removal (1.6L)

Removal (1.6L)

  1. Release fuel pressure. See FUEL PRESSURE RELEASE . Drain cooling system. Remove radiator, accelerator cable, air intake hose, breather hose, PCV hose, and air cleaner.
  2. Disconnect necessary coolant hoses, electrical connections, vacuum hoses and fuel lines. Remove center cover and spark plug wires. Remove wiring harness.
  3. Remove timing belt. See TIMING BELT . Remove rocker cover and semicircular packing at rear of cover.
  4. Disconnect exhaust pipe at manifold. Disconnect tension rod at rear of intake manifold. Using Wrench (MD998051), loosen head bolts in proper sequence, in 2 stages. See Fig 1. Remove cylinder head and gasket.
Fig 1: Cylinder Head Bolt Removal & Installation Sequence (1.6L)
G90F08782Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals