LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 1991 >> Precis Base, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.5L 4-CYL - VINS [A,J,X] & 1.6L 4-CYL - VIN [Y] >> Removal & Installation >> Cylinder Head >> Installation (1.6L)

Installation (1.6L)

  1. Install cylinder head. Use new gasket. Ensure identification mark on head gasket is toward timing belt side and faces up. See Figure. DO NOT apply sealant to head gasket. Install head bolts and washers. Ensure washers are installed in proper location.
  2. Tighten bolts to specification in sequence, in 2-3 stages. See Figure. To complete installation, reverse removal procedure.
  3. Apply sealant to rocker cover sealing areas and sealing areas of packing. See Fig 1. Apply gasoline to "O" ring on fuel line before connecting fuel line to fuel rail. Adjust all control cables.
Fig 1: Applying Sealant To Rocker Cover Sealing Areas (1.6L)
G90H08783Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals